Forum Discussion
Nat_Thirasuttakorn
Employee
Employeeuse rule to configure destination address translation
Hi all,
is it possible to use rule to control destination address translation
for example,
if uri = *.f5.com
no address translation
pool prox...
Disabling NAT on a pool will prevent the source IP addresses of connections load balanced through that pool from being translated by a NAT, just as disabling SNAT on a pool will prevent the source IP addresses of connections load balanced through that pool from being translated by a SNAT.
Is there an iRule command to disable destination address translation? Something equivalent to "translate addr disable" on the VIP?
