Forum Discussion

Nimbostratus

Jan 18, 2018

traffic from APM to Domain Controller

Hello, We have configured the APM for exchange 2016 to use NTLM in test environment and it is working fine . the communication from LTM is open to DC over the management interface. Now moving on...

application delivery

BIG-IP Access Policy Manager (APM)

devops

LTM

kolom_265617
Jan 22, 2018
Hello Maryam,

You can use either Management interface or TMM interface to reach your Domain controller. If a destination address does not match that of the management interface network, and no static route is specified besides a default management gateway, the system uses the default gateway that the TMM specifies.

So just make sure that the DC is reachable to F5 , and the required ports and services is enabled.

Note : if SMBv1 is disabled on the DC . this will cause the BIG-IP APM system not to be able to successfully authenticate clients using NTLM. https://support.f5.com/csp/article/K55889450

kolom_265617

Cirrostratus

Hello Maryam,

You can use either Management interface or TMM interface to reach your Domain controller. If a destination address does not match that of the management interface network, and no static route is specified besides a default management gateway, the system uses the default gateway that the TMM specifies.

So just make sure that the DC is reachable to F5 , and the required ports and services is enabled.

Note : if SMBv1 is disabled on the DC . this will cause the BIG-IP APM system not to be able to successfully authenticate clients using NTLM. https://support.f5.com/csp/article/K55889450