Forum Discussion

JN's avatar
JN
Icon for Nimbostratus rankNimbostratus
Nov 30, 2012

Sync "shows" ok, but not...

Trying to sync a pair of active/standby units. (10.2.3, 1600's). Configsync status shows that it's sync'd, and I get no errors when syncing either through the GUI or through the CLI. However not everything is coming over. For example, virtual servers on the active unit are not coming across.

 

I have a case open w/ support now. Actually, they had one open previously and ended up going line by line on the bigip.conf file to match them up (doesn't seem like a solution to me). And clearly that did not fix whatever root problem there is.

 

Is there a known issue?

 

Things to check or test?

 

 

I appreciate the advice.

 

 

Justin

 

config
design

3 Replies

  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Nov 30, 2012
    However not everything is coming over. For example, virtual servers on the active unit are not coming across.does the virutal server use non-floating selfip as virtual address?
  • JN's avatar
    JN
    Icon for Nimbostratus rankNimbostratus
    Dec 03, 2012
    none of the virtual servers use either the non-floating IP or a floating ip...all VS's use their own IP's.

     

     

    Configsync uses the "Network Mirroring" peer IP, correect?
  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Dec 03, 2012
    Configsync uses the "Network Mirroring" peer IP, correect?yes if not otherwise is specified.

     

     

    if shared configuration file is identical but gui shows different, have you tried to reload the configuration?

     

     

    sol13030: Forcing the mcpd process to reload configuration

     

    http://support.f5.com/kb/en-us/solutions/public/13000/000/sol13030.html