Forum Discussion
Tariq_Ali_90158
Nimbostratus
Nimbostratussomething very simple - f5adduser
I am trying to add user through CLI. I could use following command to add a new user with read only access, but I can't figure out command to use if I need to add user with read only (GUI) access for LDAP configured box.
f5adduser -r 700 -S testpwd test_account
4 Replies
- The_Bhattmanhave you looked at the following on Ask F5 website
https://support.f5.com/kb/en-us/solutions/public/5000/600/sol5661.html
I am not sure if it answers question
CB 
Tariq_Ali_90158I thank you very much. This article doesn't address question about how to add user's in an LDAP environemnt. I will continue to look around.
hoolioCirrostratus
Which LTM version are you running? For 9.4.x+, you should be able to get more info by checking 'b user help' and 'b remote users help':
NAME
remote users - Configures the default role, partition access, and con-
sole access for all remotely authenticated user accounts that have not
been added as local user accounts on the BIG-IP system.
Note: To assign a different access to a specific remote user, you must
create a local user account for that user. See the user command man
page for more information.
...
Aaron- Tariq_Ali_90158I am running 9.4.7. I will go over the commands stated. BTW we were able to find the comamnd to create user's I'd's for GUI read only access in LDAP environment.
It is f5adduser -r 700 -ns user_id
Everyone ty for assisting on this.
