Forum Discussion
Juha_47876
Nimbostratus
NimbostratusSNAT based on destination IP
Hi,
I would need a solution for the following requirement.
I have a pool of servers and their internal IP addresses are e.g.:
pool POOL_WITH_6NODES {
lb method me...
Hamish
Cirrocumulus
CirrocumulusYou passing through a firewall? If so, NAT there.
If not...
You could create a VS that the outbound traffic is forwarded through. If these are the only 6 servers on the VLAN, you can set SNAT on the VS. If there's more servers on the VLAN and you don't want to SNAT them, then you could put an iRule on the VS to check the clientip and perform a SNAT if and only if the clientip is one of the 6 and the destip is the target (Or in a target list) [Note, I'd use a datagoup/class for holding the IP addresses of the clients and servers...
H
