Single Arm Installation of LTM

Thanks Nitass for your reply so let me just re-confirm and understand the things again... in one arm installation there is no need for multiple VLAN's to keep as internal and external ????right???

 

 

Now......

 

 

In case if I have a LTM fail-over unit, do i have to do these trunk configuration on the fail-over unit as well or it can get these configuration on synchronizing the two units.

 

 

Also in case of Active/Standby configuration can I keep the LACP mode as active on both of the units? or it should be Active on active unit and Passive on Standby unit?????

 

 

Also,

 

I have 2 cisco switches one active and other as standby I am planning to keep 4-ports (Gig) of BIG-IP LTM (Active unit) to active Cisco Switch and another 4-ports (Gig) to the standby Cisco switch as trunk group and same for the Standby unit of LTM. Now the problem is If i take out one port from each LTM unit and keep it for network fail-over as separate it will disturb my design as described above. So keeping in view the design situation and best practice what do you suggest to be done now????

 

 

Regards,