Forum Discussion
thennessey_2290
Nimbostratus
NimbostratusSet existing monitor on existing node in Powershell - F5 Big-IP
I know how to create a new node in Powershell. I've read you cannot apply a health monitor upon creation. So how can I add a health monitor afterwards? The name of the node is "TestNode1" and the ...
thennessey_2290Nimbostratus
NimbostratusThanks, I had seen that page but it creates the monitor, it doesn't apply an existing monitor. I will give your script a try. Is there a reason you use arrays (@) in this script? Is it necessary to apply a single monitor to a single node? Thanks for the help.
cjunior
Nacreous
NacreousIt sets the icmp monitor as a single monitor to node, it is not creating a new one.
My arrays were used just to make it clear that the method signature.
Usually, I don't need to monitor the node, I do that in the pool.
I hope to have it understood.
Regards.
