Forum Discussion
Ossar_178453
Altostratus
AltostratusSaving a UCS prompts me for a password
Hello,
When saving a UCS on a specific device, but no other device, prompts me for a password. I do not know what the password is for and it does not matter what I input, it works just fine. What i...
Ossar_178453Altostratus
AltostratusI think all of you are missing the point.
On the UCS save I input "123". On the UCS load of the created archive I input "456". It still loads fine.
The password prompt is for something else in the archive. The prompt on the load operation is probably due to the fact that a load operation is actually a save of /var/local/ucs/cs_backup.ucs and then a load of the archive specified. The password prompt is for the cs_backup.ucs.
There is no config.encryption db value in v11, and trying to list it:
list sys db config.encryption
01020036:3: The requested BIGdb variable (config.encryption) was not found.
I even tried applying a UCS from a different unit, void of this problem, but it still asks for a password on a subsequent load operation.
Ossar_178453Altostratus
AltostratusThanks! Did that, will see what happens. Will report back if I ever get to a conclusion
