F5 is upgrading its customer support chat feature on My.F5.com. Chat support will be unavailable from 6am-10am PST on 1/20/26. Refer to K000159584 for details.

Forum Discussion

SalishSeaSecurity's avatar
SalishSeaSecurity
Icon for Altostratus rankAltostratus
Mar 13, 2023

rSeries clean shut down

I am remotely managing some rSeries appliances for a customer.  Two of the appliances must be physically moved soon.  I have found KB articles telling me what NOT to do when powering off a rSeries ap...
application delivery
rseries
SalishSeaSecurity's avatar
SalishSeaSecurity
Icon for Altostratus rankAltostratus
Mar 13, 2023

I did read that KB article, thank you.  Since it was written as a solution to a problem, rather than a SOP, I wasn't sure it applied.  These rSeries are running F5OS 1.3.2, and are NOT configured for appliance mode.  The release notes for F5OS 1.3.2 do explicitly state that running 'halt' and then physically removing power from the appliance is an acceptable procedure in appliance mode or non-appliance mode under this version.  We can do that, though, I would prefer to see an acknowledgment from F5 that 'shutdown -h now' is acceptable and safe in non-appliance mode.

 

  • Mohamed_Salah_'s avatar
    Mohamed_Salah_
    Icon for MVP rankMVP
    Mar 22, 2023

    Hello,

    As per the article "K22954168", i think is it safe to use any command if the appliance mode is disabled, and the concer was only when the appliance mode enabled. as you mentioned you can go with the hald procedure, and you can check the below article as well:

    "Alternatively, you can power off the system using the halt command (do not use the -p option). Once the serial console reports the device has been halted, then unplug the power to the appliance. In this case the "last power state" of the appliance is "powered on". When input power is re-applied, the appliance will automatically power on and boot."

    https://my.f5.com/manage/s/article/K000132560

     

    Thanks,