Forum Discussion
Youssef_Ghorbal
Cirrus
CirrusRoute domains and Pool members
Hello,
I have two route domains (ID 1 and the default, ID 0) My Virtual Server is bound to Route Domain 1. My pool has only members that are bound to default Route Domain.
Is there any way ...
Have you tried making Route Domain ID 0 the parent of ID 1?
Chase_Abbott
Employee
EmployeeDang, my pretty answer blew up in my face. We did this setup for Lync to mask public versus private IPs with the virtual on default vlan (v100) and all nodes living on %1 (v101). In this instance we didn't have a SNAT on the incoming VS but we DO have to add outbound virtuals to allow the nodes to route back through LTM. In this case I had an outbound_lync virtual with the following:
Type: fastL4 Source: 0.0.0.0%1/0 Destination Network Addr: 0.0.0.0%1 This did SNAT out via the (v101) and used an address available on the default vlan.
Makes me wonder if the reset is on the VS or behind during transit to the node or back?