Forum Discussion

rgk_76855's avatar
rgk_76855
Icon for Nimbostratus rankNimbostratus
Jun 24, 2010

Problem with Redundancy Mode

Dear All,     My Redundant LTM is becoming Active however it is configured as a Standy unit 2,     Active System Code = BIG-IP 9.2.4 Build 13.1 (This is my active unit, however no configsy...
config
design
Chris_Miller's avatar
Chris_Miller
Icon for Altostratus rankAltostratus
Jun 26, 2010
Rehan - I'd probably quit using network failover and see if that solves the problem. It shouldn't affect anything, but it wouldn't hurt...Also - as I mentioned, check out the logs on both units when the secondary goes from standby to active...it shouldn't do that unless it detects an issue with the voltage cable.