Forum Discussion

Pael_74584's avatar
Pael_74584
Icon for Nimbostratus rankNimbostratus
May 06, 2010

Priority Group Activation for 2 members

I have a pool with only 2 members. I have set 1 server with Priority group2, and another with Priority Group 1. Priority group is enabled with condition of Less Than 1 available member. However, I'm still seeing that my Priority Group 1 is active. Does it mean I need to have at least 2 members per Priority Group?

 

config
design
  • hoolio's avatar
    hoolio
    Icon for Cirrostratus rankCirrostratus
    May 06, 2010
    Hi Pael,

     

     

    If you specify a minimum active count of Less Than 1 LTM should only use the one server which has the higher priority of the two pool members. Are you seeing both servers used at the same time or just one but the wrong one?

     

     

    Aaron
  • Michael_Yates's avatar
    Michael_Yates
    Icon for Nimbostratus rankNimbostratus
    May 06, 2010
    Are you referring to the Priority Group 1 Member still showing active in the Pool (Still showing as Green / Available) or connections to the Priority Group 1 Member (in the Pool Statistics)?

     

     

    Keep in mind that any connections that existed at the time you set-up the Priorty Activation Groups will persist until their session ends.

     

     

    I would suggest that you wait until all of the connections have gone away and zero the statistics, then come check later to verify.