Forum Discussion
Nimbostratuspersistence reocrd on pool member
Hi all
By using web GUI Overview -> Local traffic -> persistence record -> only able search by persistence value and define which pool goes to.
My status is I have Pool Member with 2 IP (A & B) and sometime the traffic goes A more offen than B. So that I want to verify the persistence value by searching Pool Member IP (A or B) to instead of the using persistence value to search Pool member
Is there any way to via web or SSH ?
2 Replies
Areast_170424Actually I know the Pool Member IP "A" but I want to know the persistence value are running on Pool Member IP "A". So that I can manually reset persistence value on "A" or move the traffic from "A" to "B"- Kevin_Stewart
Employee
Just to level set, the chosen load balancing algorithm is responsible for dividing the traffic amongst pool members, and the persistence method is used to keep an existing "session" pinned to a single pool member after that initial load balancing decision. You may get close, but you'll likely never see exactly even distribution across the pool members, especially when persistence is involved.
Can you elaborate on the persistence and load balance methods you've selected? Depending on the persistence method, you can see the persistence record table from the command line.
