Forum Discussion
SynACk_128568
Cirrostratus
CirrostratusPersistence and snat
Hi All,
if snat2vip and persistence is configured then what will be the persistence record seen in the persistence table . I am seeing :
Sys::Persistent Connections
source-address 1.23.4.5:43 2.3.4.5:23 0
What is this source-address ?
13 Replies
shaggy_121467Cumulonimbus
what type of persistence are you using?
SynACk_128568Hi Shaggy, it is source ip persitence
shaggyNimbostratus
what type of persistence are you using?
- SynACk_128568Hi Shaggy, it is source ip persitence
- shaggy
did you also try "show ltm persistence persist-records all-properties"?
- SynACk_128568Thanks shaggy i can see client-addr through this command , so it will use source address not VIP for persistence ?
- shaggywhat type of vip is the traffic going through? is it a wildcard VS or does the VS have a /32 address? you should see all four addresses (client IP, VIP address, SNAT, pool member) per line. a forwarding virtual server may only show the source, snat (if assigned), and destination
- SynACk_128568Thanks shaggy
- shaggy_121467
did you also try "show ltm persistence persist-records all-properties"?
- SynACk_128568Thanks shaggy i can see client-addr through this command , so it will use source address not VIP for persistence ?
- shaggy_121467what type of vip is the traffic going through? is it a wildcard VS or does the VS have a /32 address? you should see all four addresses (client IP, VIP address, SNAT, pool member) per line. a forwarding virtual server may only show the source, snat (if assigned), and destination
- SynACk_128568Thanks shaggy
NikhilBEmployee
You should see the source address of the client's ip. (when using snat)
