Forum Discussion
Sagar_Shah_9610
Nimbostratus
NimbostratusOSPF toggling on neighboring routers when BigIP is connected to them
Hello All,
I've BigIP 3400 LTM installed in HA mode (Active - Standby) at telecom carrier (See network diagram attached). OSPF module is licensed and running on BigIP.
I...
dennypayne
Employee
EmployeeBelieve it or not, I have actually seen a bug where if you are in vtysh and run 'show ip ospf route' it will occasionally cause an adjacency change. I think it is fixed in 9.4.6 and 9.4.7.
I have also seen an issue where for some reason when a box becomes active it does not remove the 65535 cost metric that is usually automatically applied to the standby's configuration. This should also be fixed in newer releases.
Denny
