Forum Discussion
D99
Cirrus
CirrusNew Virtual Server Pool, Self IP and routing configuration
Hi Experts, I am stuck with a situation I have a existing virtual server pool 10.60.85.0/26 and associated self IP's 10.60.85.2(non floating) & 3(floating) and gateway 10.60.85.1 on Network firewal...
D99 It sounds to me like you have automap configure as the SNAT method which will always use the self-IP of the interface closest to the destination. I would not use automap for any of your virtual servers (VS) unless absolutely necessary for various reasons that I won't go into at this moment. I recommend creating a SNAT pool and labeling it SNAT_10.60.94.5 and adding IP 10.60.94.5 to that pool and then under the new VS you will select the SNAT pool you just created called SNAT_10.60.94.5. Once you have SNAT configured the way I have defined you will now see traffic for the VS arriving as 10.60.94.5 to the destination servers.
Paulius
MVP
MVPD99 It sounds to me like you have automap configure as the SNAT method which will always use the self-IP of the interface closest to the destination. I would not use automap for any of your virtual servers (VS) unless absolutely necessary for various reasons that I won't go into at this moment. I recommend creating a SNAT pool and labeling it SNAT_10.60.94.5 and adding IP 10.60.94.5 to that pool and then under the new VS you will select the SNAT pool you just created called SNAT_10.60.94.5. Once you have SNAT configured the way I have defined you will now see traffic for the VS arriving as 10.60.94.5 to the destination servers.