Migrate to 11.2.1

and when i found this SOL , it said we can just restore *.ucs yes, you can restore v10 ucs to v11.

 

 

e.g.

 

root@(ve11a)(cfg-sync In Sync)(Active)(/Common)(tmos) load sys ucs this_is_v10_ucs.ucs no-platform-check no-license

 

 

i want to migrate from 10.2.4 to 11.2.1 but Virtual server , pool , node didn't appear when install 11.2.1 but VLAN , Interface ,... apear correcthave you tried "/usr/libexec/bigpipe daol"? it should show what problem is.

 

 

hope this helps.

i can't restore it said error

 

 

so i use command "/usr/libexec/bigpipe daol"

 

 

it said

 

 

BIGpipe server SSL profile creation error:

 

01070316:3: profile /Common/SSL_ORPG requires a certificate

 

 

what does it mean ?

BIGpipe server SSL profile creation error:

 

01070316:3: profile /Common/SSL_ORPG requires a certificate is certificate missing? can you check /config/bigpipe/bigip.conf and then run /usr/libexec/bigpipe daol again.

Does it relate with https://support.f5.com/kb/en-us/solutions/public/12000/400/sol12454.html?

 

 

cause in v. 10.2.4 , I have a problem about this and didn't fix yet

i do not know but i think the error message does not look like passphrase issue.

 

 

anyway, you may remove certificate and key configuration in /config/bigpipe/bigip.conf to let configuration loaded first and then manually upload them later.

 

It's work , I remove problem profile in /config/bigpipe/bigip.conf then load config again , now everything is fine

 

 

Thank you very much

 

 

Kob khun mak krub

Hi Folks,

 

I am upgrading my HA system from 10.2.1 to 11.2.1 HF1

 

After I finish upgrading the standby unit, it comes up as Standalone (standby). How can I do a config sync and make this node Active?

 

I do not want tany raffic interruption.

 

 

Thanks,

 

Ameya

Hi Folks,

 

I am upgrading my HA system from 10.2.1 to 11.2.1 HF1

 

After I finish upgrading the standby unit, it comes up as Standalone (standby). How can I do a config sync and make this node Active?

 

I do not want tany raffic interruption.

 

 

Thanks,

 

Ameya

Hi Folks,

 

I am upgrading my HA system from 10.2.1 to 11.2.1 HF1

 

After I finish upgrading the standby unit, it comes up as Standalone (standby). How can I do a config sync and make this node Active?

 

I do not want tany raffic interruption.

 

 

Thanks,

 

Ameya

Hi Folks,

 

I am upgrading my HA system from 10.2.1 to 11.2.1 HF1

 

After I finish upgrading the standby unit, it comes up as Standalone (standby). How can I do a config sync and make this node Active?

 

I do not want tany raffic interruption.

 

Thanks,

 

Ameya