Mgmt ip address config

Hello,

The management IP address can be added using config command as you mentioned above, and also using the below command:

#tmsh show sys managamenet-ip

both config command and the above command will show the same management IP address. Regarding the "show /sys ip-address", it shows the configured IP address on your BIG-IP, for example here is the output from my lab after running this command:

# show /sys ip-address

------------------------------------------------------
Sys::IP Address
Entry Component Object-ID
------------------------------------------------------
*:* ltm monitor http check
*:* ltm monitor https check2
default net route default_route
1.1.1.1 ltm virtual-address 1.1.1.1
2.2.2.2 ltm virtual-address 2.2.2.2
11.1.1.1 sys dns n/a
192.168.7.100 ltm node auction
192.168.7.100 ltm pool test
192.168.7.100 ltm pool ooo
192.168.8.5 ltm virtual-address 192.168.8.5
192.168.8.6 ltm virtual-address 192.168.8.6
192.168.8.88 ltm virtual-address 192.168.8.88
192.168.8.156 ltm virtual-address 192.168.8.156
192.168.9.99 cm device 301A.LAB
192.168.75.227 sys dns n/a
192.168.75.227 sys management-route default
195.242.197.155 ltm node 195.242.197.155
195.242.197.155 ltm pool motam

and the description of "ip-address" in the command is: "ip-address View configured IP addresses"

so there is only one management IP and not two. Regarding the interfaces shown on the GUI ("interface 1.1, 1.2 and 1.3") they are related to traffic processing and called TMM interfaces. The eth0 is the management interface.

BR,

Mohamed Salah