Forum Discussion
FrontmanFin
Altostratus
AltostratusMaking a default route is breaking my management auth
Hello, I have TACACS configured for Configuration Utility/GUI access and it works. My problem is, when i make a default route on the box network > routes: source: 0.0.0.0 ...
Resolved my issue. I made management-routes but that wasn't populating in the kernel route table (route -n from bash)
so i added the routes to my TACACs
route add -net [network] netmask [mask] gw [gateway] metric 4096
and that seems to have worked.
FrontmanFinAltostratus
AltostratusResolved my issue. I made management-routes but that wasn't populating in the kernel route table (route -n from bash)
so i added the routes to my TACACs
route add -net [network] netmask [mask] gw [gateway] metric 4096
and that seems to have worked.
Paulius
MVP
MVPFrontmanFin You might consider figuring out why the routes aren't being added to the kernel route table rather than manually adding them. A lot of times OS level changes do not carry over after upgrades and you could encounter an issue when you perform one because of this.