Forum Discussion
JG
Cumulonimbus
CumulonimbusLTM v11.3.0 : syncing : "error" messages
When I sync from active to standby, there seem to be two steps in the process, or the sync status gets refreshed twice. I get two different messages: the first is something like: "Not all deviced are...
vaibhav
Cirrostratus
CirrostratusFirst thing i would suggest you to do is check all the load balancer config in the group. make any minor changes on your load balancer and check that config is replicated on the other unit or not.
As of my knowledge the end message is the one that should be considered but you can not ignore the first message.
Check what happens when you test it.
