Forum Discussion
CirrocumulusLTM Monitor ServicePort
CirrocumulusHello Kai,
thank you, but could you tell me, if this is under Monitor or Pool.
In the Monitor the Alias Service Port the default-Setting is "All Ports", do you mean this?
MVPHi kgaigl,
When you create a Pool Member, you can set it ports to "* All Services".
In this case, the Pool-Member will inherit the DST port of the VS when forwarding to it. The VS could also be set to * All Services, which would allow you to setup a VS-many-to-many-Pool port mapping.
When working with such * All Services rule sets, then you have to keep in mind that the Health-Monitor wont know which port to monitor, so you have to specify a port at the Monitor-Level.
Only if you have specified a Port at your Pool-Member, the monitor will become able to inherit the Port of the Pool-Member via the default "* All services" option.
Cheers, Kai
- kgaigl
Kai_Wilke wrote:Only if you have specified a Port at your Pool-Member, the monitor will become able to inherit the Port of the Pool-Member via the default "* All services" option.
Ok Thank you, but this last sentence is my Problem, I think this has worked all the time, and with new pool not
But to be sure I set the Alias Port, otherwise I could use same Monitor for different Pools
btw: version is 16.1.3.1
- Kai_Wilke
Did you set the Port on the pool level? And does the monitor not inherit its settings? Did you double checked your configuration?
Cheers, Kai
