LTM - how to setup a VS for service bus?

@R Marc, thanks for your help. Here is the output:

VS's (there are 2, 1 for each port): ltm virtual _vip_otv_svcbus_TEST_https_9354 { destination 10.11.8.11%60722:9354 ip-protocol tcp mask 255.255.255.255 partition DevTest_Domain_Default_Partition persist { /Common/source_addr { default yes } } pool _pool_otv_svcbus-TEST profiles { /Common/fastL4 { } /Common/http { } } rules { syslog_http_logging_debug } source 0.0.0.0/0 source-address-translation { type automap } vs-index 22 }

ltm virtual _vip_otv_svcbus_TEST_https_9355 { destination 10.11.8.11%60722:9355 ip-protocol tcp mask 255.255.255.255 partition DevTest_Domain_Default_Partition persist { /Common/source_addr { default yes } } pool _pool_otv_svcbus-TEST profiles { /Common/fastL4 { } /Common/http { } } rules { syslog_http_logging_debug } source 0.0.0.0/0 source-address-translation { type automap } vs-index 23 }

Pool: ltm pool _pool_otv_svcbus-TEST { members { ST-SVCBUS-001:any { address 10.11.31.43 session monitor-enabled state up } ST-SVCBUS-002:any { address 10.11.31.44 session monitor-enabled state up } ST-SVCBUS-003:any { address 10.11.31.45 session monitor-enabled state up } } monitor /Common/gateway_icmp partition DevTest_Domain_Default_Partition }

I don't think the client-ssl-profile is being used for these? How can I tell? (sorry, I'm new to the F5s).

Thanks for the help, Scott