Forum Discussion
chungyu_16122
Altostratus
AltostratusLoad Balancer Traffic Design without using Self IP
Hi everyone
I would like to know if anyone has used a setup that has one large subnet as an outside Vlan (for service VIP's) and it routes to all the different server vlans. Typically, we setup ...
I have this type of setup where there is no self-ip on the LTM and it works perfectly fine. Reason - All the IP addresses (VIP, Pool members) are advertised in the same routed protocol. I have not come through any issue with this design. It's configured in one arm mode and also uses snat pool.But on F5, you will have to set a default route for reverse traffic.
SWJO
Cirrostratus
CirrostratusHi
The best solution for your question is DSR(direct server return).
exactly L3 N Path Routing.
But there is limit on this topology.
Regards,