Forum Discussion
gannu_31427
Nimbostratus
NimbostratusLACP portchannel configuration
my configuration look like this
switch configuration
----------------------------------
interface Port-channelX
switchport
switchport trunk allowed vlan XX
switchport mode trunk
logging event link-status
load-interval 60
-------------------------------
interface GigabitEthernet2/11
switchport trunk allowed vlan xx
switchport mode trunk
channel-protocol lacp
channel-group 3 mode active
------------------------------------------
interface GigabitEthernet2/12
switchport trunk allowed vlan xx
switchport mode trunk
channel-protocol lacp
channel-group 3 mode active
F5 configuration
------------------------------
LACP - enabled
Mode- Active
Timeout- short
link selection : auto
Frame Distribution Hash : Destination Mac address
interfaces: 1.1 and 1.2 are avaialble
-------------------------------------------------------------------------
still i couldnt ping the VLAN XX from F5, What could be the reason?
3 Replies
Michael_YatesHi gannu,
Try changing your LCAP Timeout to Long and see if the pair comes up and works properly.
Long: Specifies that the system sends an LACP control packet every 30 seconds.
Short: Specifies that the system sends an LACP control packet every 1 seconds.- nitass
Employee
would you mind also showing vlan configuration on bigip?
tmsh list net vlan 
SunnyNguyen_333Dear All,
I also config LACP with Juniper SRX. Do you have steps to config this?
Thanks and best regards, SunnyNguyen
