Forum Discussion
Aantat
Cirrus
CirrusIs it possible to add remote device to BIG-IQ?
Hi team, Is it possible to add remote device to BIG-IQ? The document says that "The BIG-IP device must be located in your network", so It's not possible to manage BIG-IP devices located in another ...
AantatCirrus
CirrusIt should be routed via VPN tunnel to second DC or it can be managed via public IP? Is there any kind of documentation about that?
Paulius
MVP
MVPAantat If you can route to the BIG-IP device from the BIG-IQ you can add the remote device. Going over a VPN or public internet will most likely have too much latency for the BIG-IQ to manage the BIG-IP properly. The BIG-IQ can communicate out of any IP it has as long as you have the appropriate route and NAT if you are traversing the public internet. I don't know of any documentation that would go over those scenarios specifically because it's just the basics of routing so if you can route to it you can add it.
