Forum Discussion
freman_200486
Nimbostratus
NimbostratusiRule matching destination address using VPN
Hello,
I have a F5 running LTP/APM and I'm using the EDGE-client for SSL-VPN. As it is now I'm using a full tunnel since I have both outside and inside of the F5 connected to a firewall.
Right no...
freman_200486Nimbostratus
NimbostratusHello again,
I tried your suggestion above but I get no hits on the iRule when I look at my logging.
Might try to do a partition and a route-domain and connect that to my firewall. Then the F5 can still be the termination point for my vpn and I do NO NAT and then let the firewall do the natting externally instead.
It would be nice though to be able to sove this in the F5 anyway. :)
Thank you for your help so far :)
Regards
// Fredrikk
- Kai_Wilke
MVP
Hi Freman, The available information on the rather new "related-rules" command and the valid usecases are almost non-existent. So you may ask the F5 support for further assitence and keep us then updated... :-) Cheers, Kai
