Forum Discussion
Martin_58375
Nimbostratus
NimbostratusiRule : snatpool first or pool member selection first
i have a iRule like below
iRule_mail_snat
when CLIENT_ACCEPTED {
if {[IP::remote_addr] equals "202.1.1.1"} {
snatpool snatpool_A
pool Pool_A
}...
What_Lies_Bene1
Cirrostratus
CirrostratusYou could specify any SNAT address you liked, the F5 wouldn't reset anything unless the traffic behavior/routing back to it was wrong.
What IPs are in the SNAT Pool? Does server 3.3.3.254 have a route back to 1.1.1.1 via the F5, on the same VLAN?
