Forum Discussion
Hi Marcel,
Hope I can help. A Std Virtual server with a pool does destination NAT by default. So VS would terminate on 10.44.36.123 and then proxy traffic to pool member 192.168.30.2. If you need Source NAT, to allow for routing back to external client then you can simply select Automap on the VS (Under Source Address Translation).
You can use a NAT listener too to achieve this same affect, although there is no load-balancing/pool and you don't configure a port either (i.e. all traffic is allowed). Here you would configure a NAT with origin address 192.168.30.2 and translation address of 10.44.36.123.
Both a VS and a NAT are "listeners".
If you had both configured, however, then the VS takes precedence over the NAT listener.
Hope this helps,
N