Forum Discussion

Altostratus

Sep 12, 2013

High Availability - functions well, however peer device shows offline.

Hello Folks, I have 2 LTM deployed in HA, running over firmware version 11.2.0 However, one of the devices shows offline status in peer list. At the same time the device is in Sync, failover wor...

device is offline

high availability

management

Chris_18457
Nov 11, 2013
I ran across this thread while troubleshooting a similar issue, and I thought I would add what corrected the issue on my end. After clustering my 2, 6900s the configurations sync'd but the HA status for the peer device showed down (on both 6900s). After going round and round, I found that my HA self IPs on each device were set for "allow none". I changed them to "allow default" and BAM! Issue fixed.

Chris

Chris_18457

Cirrus

I ran across this thread while troubleshooting a similar issue, and I thought I would add what corrected the issue on my end. After clustering my 2, 6900s the configurations sync'd but the HA status for the peer device showed down (on both 6900s). After going round and round, I found that my HA self IPs on each device were set for "allow none". I changed them to "allow default" and BAM! Issue fixed.

Chris