Forum Discussion
CraigM_17826
Altocumulus
AltocumulusHealth monitor issue
Hi all,
we have a rather pressing and odd issue. Like most users I have setup health monitors to monitor the individual nodes within a pool. These health monitors used to work. Now ...
CraigM_17826Altocumulus
AltocumulusPosted By hoolio on 01/21/2010 4:51 PM
Is there a node or pool member-specific configuration for the member(s) you're seeing this on? It sounds like the member might have monitoring set to none either on the pool member or maybe the node definition.
No, both pool members inherit the monitor from the pool. I did try removing the monitor from the pool and then adding the monitor to both nodes, but the behaviour was the same, a status of the blue box.
Posted By hoolio on 01/21/2010 4:51 PM
Can you configure the simple TCP monitor on the pool? Then please post an anonymized copy of your pool definition using 'b pool POOL_NAME list' and the status using 'b pool POOL_NAME show'.
Will do, but not until Monday.
Posted By hoolio on 01/21/2010 4:51 PM
Also, I added a wiki page on some tips for troubleshooting monitors. You might find something useful there. Or if you figure out another method that works for you, feel free to add it.
Wonderfull. I'll have a look. Once again thanks for all of your help.
Regards
Craig
