Forum Discussion
Sero_83363
Nimbostratus
NimbostratusFloating and self IP configuration
I could use some advice on setting up a new self and floating self IP on an existing pair of 10.1.0 F5's running LTM configured as active and standby. These will be for a new vlan. I have some experi...
nathe
Cirrocumulus
CirrocumulusSero,
1) yes. But this is only used for active/active setups. I'd chose unit id1 here
2) self IPS (non floating) are not a shared config so manually configure the standby unit.
3) my advice, in an active/standby setup is to use id 1
Hope this helps, N
