Forum Discussion

Stig_Dahl_82658's avatar
Stig_Dahl_82658
Icon for Nimbostratus rankNimbostratus
May 08, 2008

Finding out ssl::mode on serverside

I use a vip that has serverssl enabled. On one specific pool I should use "SSL::enable serverside" and on the others "SSL::disable serverside".     This works fairly well, but how do I find...
application delivery
dev
devops
iRules
Stig_Dahl_82658's avatar
Stig_Dahl_82658
Icon for Nimbostratus rankNimbostratus
May 12, 2008

Posted By hoolio on 05/08/2008 11:43 PM

 

 

What event are you using SSL::mode in? Can you post your full rule or the relevant portions?

 

 

Aaron

 

 

 

I'm using HTTP_REQUEST and HTTP_REQUEST_DATA, since I need to check POST-requests.

 

 

It would be a good thing if I could use a generic log-line at the end of the rule that checked what pool-member was selected and protocol and so on. I can check for pool-member with LB::server but not if I'm using SSL or HTTP as protocol.

 

 

And the sometimes I get the wrong protocol to the server, so to find out what ssl-mode on the serverside and not only the client-side would be nice.

 

 

I'm not attaching any rule, since this is an generic question of the possibilitys reading variables and states.

 

 

Stig