Forum Discussion
abachman_72712
Nimbostratus
NimbostratusFilter by incoming IP address
I need to write an iRule for a pool that will direct traffic to the correct member by incoming IP address. The pool members are setup to push traffic to member on service port 9081.
(e...
hoolio
Cirrostratus
CirrostratusWhat protocol/type of application is this for? Is it TCP, HTTP, something custom built on UDP, etc?
If you have IP address for the VS that's different than the two servers it should be very simple to configure. Just add the two servers to a pool with server1 at a higher priority and configure a VS which references that pool. If you need to rewrite the TCP or HTTP payload based on the destination IP address, you can do that using a stream profile or by buffering the content with TCP::collect or HTTP::collect.
Aaron
