Forum Discussion
rgordon_01
Nimbostratus
Nimbostratusfailover port 2000 series how it works
I've configured 2 new 2600 LTM devices. I am not using network failover. I am using the crossover cable that came with the devices and have it connected into the failover port on each. Is there so...
rgordon_01Nimbostratus
NimbostratusI've also enabled network failover and it's still not working correctly. here's my results:
serial | Eth int 4 network failover| Box A | Box B | expected
connectedconnected active standby yes disconnected connectedactive active no connecteddisconnectedactive standby yes disconnecteddisconnectedactive active yes
If I take hardwired completely out of the picture (b/c at this point I can't seem to get it working) and only use network failover both units show active. Hardwired is not required right?
