Forum Discussion
portoalegre
Nimbostratus
Nimbostratusfailover config
I've setup 2 new units (Active/Standby)
PS: I do not have fail-back enabled on both units.
When a port channel fails on Active unit Standby goes to Active for example, 5 mins later port cha...
portoalegreNimbostratus
Nimbostratusok, both units have a weight of 40 (4 x ports trunked), I changed the Active bonus to 5 on each unit. When I failed the Active unit (forced Standby), the Standby unit went into Active mode and stayed there.
However I did notice the traffic scores are the same, i.e - 12000 vs 4000. Why does not this change and what makes up these scores? Does anyone know. For me the scores should be changed after failing over but does not. i.e
)(Active)(/Common)(tmos) sh cm traffic-group all-properties
---------------------------------------------------------------------------------------------------------
CM::Traffic-Group
Name Device Status Next Auto Failback Failover
Active Time (in sec) Score
---------------------------------------------------------------------------------------------------------
traffic-group-1 unitA standby true 60 12258
traffic-group-1 unitB active - 60 4224
traffic-group-local-only - - - 60 -
