Forum Discussion
portoalegre
Nimbostratus
Nimbostratusfailover config
I've setup 2 new units (Active/Standby)
PS: I do not have fail-back enabled on both units.
When a port channel fails on Active unit Standby goes to Active for example, 5 mins later port cha...
portoalegreNimbostratus
NimbostratusStanby unit
root@(standby-f5)(cfg-sync In Sync)(Standby)(/Common)(tmos) show sys ha-group detail
---------------------------
Sys::HA Group: Port-Channel
---------------------------
State enabled
Active Bonus 0
Score 40
---------------------------------------------------
| Sys::HA Group Trunk: Port-Channel:Port-channel104
---------------------------------------------------
| Threshold 0
| Percent Up 100
| Weight 40
| Score Contribution 40
Active Unit
[root@-f5:Active:In Sync] config tmsh show sys ha-group detail
---------------------------
Sys::HA Group: Port-Channel
---------------------------
State enabled
Active Bonus 0
Score 40
---------------------------------------------------
| Sys::HA Group Trunk: Port-Channel:Port-channel104
---------------------------------------------------
| Threshold 0
| Percent Up 100
| Weight 40
| Score Contribution 40
