Forum Discussion

Amit_Bhatnagar_'s avatar
Amit_Bhatnagar_
Icon for Nimbostratus rankNimbostratus
Dec 04, 2013

F5 with Lync 2010

Hi,

 

Currently at a client site, helping them load balance the Lync Servers using F5 and running into some configuration issues. My setup (Image attached) is all configured but I am confused about how to configure the internal Interface of Edge Servers on F5. I mean do I use SNAT for traffic leaving the Edge Servers to the Internal Network towards Front End Servers or configure F5 to act as DG and then the F5 should forward the traffic to the Firewall. Please look at the image and suggest me on how F5 should be configured.

 

BIG-IP Access Policy Manager (APM)
design
devops
iApps
lync 2010
microsoft
security
  • Amit_Bhatnagar_'s avatar
    Amit_Bhatnagar_
    Icon for Nimbostratus rankNimbostratus
    Dec 05, 2013

    Hi, We were able to get it working by following this guide. Thanks!

     

    https://devcentral.f5.com/articles/the-hopefully-definitive-guide-to-load-balancing-lync-edge-servers-with-a-hardware-load-balancerComment2090989

     

  • mikeshimkus_111's avatar
    mikeshimkus_111
    Historic F5 Account
    Dec 04, 2013

    Hi Amit, the topology we've tested would have the Edge internal virtual servers located on the F5-2 BIG-IP, not F5-1. You would SNAT the traffic destined for the FE servers at F5-2.

     

    The Lync iApp is based on this topology. Are you using the iApp template?

     

    thanks Mike

     

  • Amit_Bhatnagar_'s avatar
    Amit_Bhatnagar_
    Icon for Nimbostratus rankNimbostratus
    Dec 04, 2013

    Could not load image so adding image here. Even Editing was not allowed. http://i41.tinypic.com/27yaadw.jpg