Forum Discussion
Milady_KC_11599
Altocumulus
AltocumulusF5 Lab Module 3
Hi! I'm following the F5 Lab. I finished Lab 1 and 2 within 2 hours and the next day I tried to open the 3rd lab. It brings me to the Setup Utility and I cannot see the System where I can import the Module3_Lab_begin.ucs. Am I going to repeat Lab 1 and 2 again? I don't think I can finish Lab 3 within 2 hours if Im going to repeat it again.
Pls help. Thanks!
I just tried to log back in yesterday and it is already good. Back to normal with no license issue.
Thanks for the comments.
Milady_KC_11599Update:
I tried to do the setup again. And import the Module3 lab UCS but going to the network map I don't see the pools. And license is not activated....
:(
- Milady_KC_11599
Now Im lost and I can only see that the license for this device is not operational
- boneyard
MVP
re-license the system?
- Milady_KC_11599
This is F5 Free Lab on their website.. Not my own F5 device.
- boneyard
ah, perhaps it has an issue or such. is there a contact there you can reach out to?
If you are using one of the labs that you accessed over F5 University that is in the SkyTap environment, and you are still experiencing an issue, you can send an email to wbtsupport@ for help.
oscarnet_69487Nimbostratus
HI Milady :
i guess you ucs file is from different device . i suggest renew you F5 Essentials WBT Lab. it will be good way.
if on next time, you want to restore f5 ucs on you don't device .
use command line, it will be fine.
tmsh load sys ucs 2017xxxx_F5_WBT_Module3_lab.UCS no-licensehave a good day!!!
- Milady_KC_11599
I just tried to log back in yesterday and it is already good. Back to normal with no license issue.
Thanks for the comments.
