Forum Discussion
cpt_ri_F5
Cirrostratus
CirrostratusF5 Connection Mirroring question
Hello, show sys connection type mirror This command should show the mirror connections on the Stanby? LTM BIG-IP Thank you
Hello,
No, the connections are not mirrored !
To share in case it might help someone someday: I had a TG conf problem, the VS was configured in the TG1 and nexthop (floating self-ip) in the TG2, I configured everything in TG1, and it works.
Thank you Mohamed_Ahmed_Kansoh M_Saeed
cpt_ri_F5Cirrostratus
CirrostratusHello, thanks for your feedback
I see connections only on the Active
I checked the configuration, it looks ok,
I see : Aborts + Errors on Standby
Primary Secondary : connected
Active:In Sync] ~ # tmsh show sys ha-mirror
--------------------------------------------------------------------------------------------------------------------
Sys::HA Mirror Status
--------------------------------------------------------------------------------------------------------------------
Traffic Group TMM Primary Secondary Aborts Overflows Errors Buffered L4 Mirror L7 Mirror L7 Failed
--------------------------------------------------------------------------------------------------------------------
traffic-group-1 [0.0] connected connected 0 0 0 0 4 0 0
traffic-group-1 [0.1] connected connected 0 0 0 0 0 0 0
traffic-group-1 [0.2] connected connected 0 0 0 0 2 0 0
traffic-group-1 [0.3] connected connected 0 0 0 0 2 0 0
!
Standby:In Sync] ~ # tmsh show sys ha-mirror
--------------------------------------------------------------------------------------------------------------------
Sys::HA Mirror Status
--------------------------------------------------------------------------------------------------------------------
Traffic Group TMM Primary Secondary Aborts Overflows Errors Buffered L4 Mirror L7 Mirror L7 Failed
--------------------------------------------------------------------------------------------------------------------
traffic-group-1 [0.0] connected connected 4 0 2 0 0 0 0
traffic-group-1 [0.1] connected connected 4 0 2 0 0 0 0
traffic-group-1 [0.2] connected connected 4 0 2 0 0 0 0
traffic-group-1 [0.3] connected connected 4 0 2 0 0 0 0
Hi cpt_ri_F5 ,
Have you configured the mirroring within specific ( Virtual server , Source address persistence ... ) ?
you can't rely only Connection mirroring with HA Setup.