Exchange 2013 CAS Template Error

Oscar, just a thought as I've not seen this before. In the iApp template have you enabled Analytics? If so does the iApp work if you don't select it?

Do you have AVR provisioned on the box?

N

Try toggling the AVR enabled state under System/Provisioning. i.e. if it is enabled, disable it and vice versa.

If that does not do it, and you cannot wait until support gives you a solution, do the following:

Comment that line out and add another under it like this:

set avr_provisioned [iapp_get_provisioned avr]
set avr_provisioned 0   

 Or

set avr_provisioned 1

set it to 0 or 1 depending on whether or not you want the AVR configuration added to your exchange.

Thx for the response. I receive the error as soon as I select the template from the dropdown list on the Template Selection screen. It never loads a form like it does when I select f5.http for example. And I don't believe I have AVR enabled as it's a test system with a basic config.

Under Presentation, try taking out these two lines:

    choice analytics_provisioned tcl { expr { [tmsh::run_proc \
        f5.iapp.1.1.0.cli:iapp_get_provisioned avr] ? "yes":"no" }}

Hi Oscar, I apologize for the difficulties you're having with the iApp template. The error you're seeing is actually caused by tmsh commands in a shared library (f5.iapp.1.1.0), so editing the iApp template itself will probably not help.

There may be an error in the support matrix for this template (it may not be supported for versions of BIG-IP earlier than v11.2, for example). We will discuss this with the iApp development team and provide you with a recommended course of action.

thanks

Mike

Hi again Oscar,

I was unable to repro this error on a v11.1.0 HF10 BIG-IP. Would you be able to post the sanitized contents of your bigip_script.conf file here, using the preformatted code option to make it more readable?

Also, I'm not sure which hardware platform you're on, but if possible we recommend upgrading to at least BIG-IP v11.2.1. There was an issue with versions 11.0 and 11.1 that causes problems with monitors that were created by an iApp: https://support.f5.com/kb/en-us/solutions/public/13000/800/sol13813

Mike