Forum Discussion

Joe_Erchul_4263's avatar
Joe_Erchul_4263
Icon for Nimbostratus rankNimbostratus
Dec 11, 2008

"Error executing shell command" when doing a ConfigSync

Hi, all. I've got a pair of Big-IP LTM 6800s in Active/Standby mode. These units have been able to successfully sync in the past, but now when I try to sync from the active to the standby, I'm getting an "error executing shell command" message in the GUI.

 

 

Any thoughts?

 

 

Thanks.

 

 

Joe
management
monitoring
  • strongarm_46960's avatar
    strongarm_46960
    Icon for Nimbostratus rankNimbostratus
    Dec 11, 2008
    jerchul, try doing it from your LTM shell on the active do:

    b config sync

     

     

    I trust commandline more than Gui any day, one other reason is that fact that my gui routes through an upstream proxy to LTM.

     

     

    its probably a problem with connecting , contact F5 support

     

  • Joe_Erchul_4263's avatar
    Joe_Erchul_4263
    Icon for Nimbostratus rankNimbostratus
    Dec 12, 2008
    Thanks, jquadri. I tried that, and received the same error message. I've opened a ticket with F5, since this active unit has changes to be synched, so I don't want to just reboot the unit. (I'm just two weeks into this job, so I'm not sure what changes were made to the active unit before I made my changes yesterday.)

     

     

    Joe

     

  • kridsana's avatar
    kridsana
    Icon for Cirrocumulus rankCirrocumulus
    Jan 29, 2013
    This happen to me too but in platform 3400. have any update?