Forum Discussion
NimbostratusDynamic NAT configuration on F5
As part of migration of application from ACE to F5, I need to create a dynamic nat pool on F5 to allow servers which have gateway on ACE(to be moved to F5)
interface vlan 133 description ACE_ROUTING ip address 10.29.20.1 255.255.240.0 alias 10.29.20.2 255.255.240.0 peer ip address 172.29.20.3 255.255.240.0 access-group input any nat-pool 133 10.78.48.1 10.78.63.254 netmask 255.255.240.0
In order to achieve this I created Data-group with the destination addresses as Hosts with address 10.78.48.1/255.255.240.0
Crete iRule
when CLIENT_ACCEPTED { if { [IP::addr [IP::remote_addr] equals 10.29.20.0/255.255.240.0] } {
snat Hosts
} }
Apply this on a forwarding VIP with Source as 10.29.20.0/255.255.240.0 over vlan 133.
This is not working though, Any other way to achieve this please let me know.
Configure AFM NAT rules.
PeteWhiteEmployee
using the snat commands means that you have to provide the IP address, not a datagroup. The simple way is to create a snatpool and use the snatpool command to assign it.
