Forum Discussion
Lior_54855
Nimbostratus
NimbostratusClone pool and change destination port
Hi,
I need to clone some of the traffic reaching a virtual server using iRule.
I wish to change the destination port of the traffic when cloning it.
The original traffic is in port 80.
The pool ...
Thomas_GobetNimbostratus
NimbostratusHi,
The destination port used to send traffic to your pool member is not defined on your virtual server.
IT's defined into your pool configuration. All your pool member will have this port, except if on a pool member you define a specific port.
Lior_54855Hi, Thank you for the reply. I'm talking about the destination ports of the pool members, not the virtual servers. From all the checks I've made, it's not possible to do. I mean if I configure clone pool named "clone_pool_1" with one pool member: 10.0.1.1:8080 And I have virtual server named "virt_1_http" 200.0.0.1, with default pool named "pool_http" with one pool member: 10.0.0.1:80 When I clone traffic from the virtual server to the clone pool, it ignores the destination port of the clone pool member and sends the traffic with destination port 80. So I was looking for a way to clone traffic and change the destination port from 80 to 8080, but it seems to be impossible without TCP::collect. Regards,
