Forum Discussion
Roger_Wolcott_7
Nimbostratus
NimbostratusCan't get bigip to route/talk to any servers.
I'm working with a BigIP 5000 with kernel 4.5.13.
Ok..so I admit I'm a relative newb to working with the bigip but am very frustrated that I can't get even a very basic thing working; load balancing iis7 web sites. I tried to find a deployment guide on how to do this but the howto docs only talk about the latest version of the software not 4.5 which is what I have.
If anybody can point me to dome deployment guide for MS IIS7 web servers I would be most appreciative.
b node
NODE 10.1.1.124 DOWN CHECKED
| node ether = 02:bf:ac:1a:9c:7b
| VLAN = MYLAB
| (cur, max, limit, tot) = (0, 0, 0, 0)
| (pckts,bits) in = (0, 0), out = (0, 0)
+- SERVICE 80 ADDR DOWN UNCHECKED
| (cur, max, limit, tot) = (0, 0, 0, 0)
| (pckts,bits) in = (0, 0), out = (0, 0)
+- SERVICE 135 ADDR DOWN UNCHECKED
(cur, max, limit, tot) = (0, 0, 0, 0)
(pckts,bits) in = (0, 0), out = (0, 0)
- The_BhattmanDid you take a look at askf5.com ?
- Chris_Miller
Altostratus
What have you done so far to setup the pool?
What interfaces do you have enabled on the big-ip? DOes it have an interface on the same subnet as your servers? 
Roger_Wolcott_7It turned out to be IPSEC that was causing the miscommunication. As soon as I turned that off, along with Firewall services, Base Filtering, and IKE then it started communicating nicely. Now I have to get around that little issue ;-)
