Forum Discussion

F5_LB_Eng's avatar
F5_LB_Eng
Icon for Cirrostratus rankCirrostratus
Dec 01, 2022

Backend server IP not visible in TCP dump

Hi , i am not able to see client IP in the TCP dump .. i see the client IP and LB - VIP only. but i am able to reach the page , but its not showing server IP in the tcp dump. below tcp dump co tc...
application delivery
  • Kai_Wilke's avatar
    Kai_Wilke
    Dec 14, 2022

    Hi F5_LB_ENG,

    > Answer to:   tcpdump -p

    Check the KB article Omar2 send you. The -p option does not work for HTTP2.

    > Answer to 1.) 

    No. I dont recommend to used the HTTP MRF Router in Gateway mode. Way too many trouble and limitations.

    > Answer to 2.) 

    I noticed the same. The functionality of the HTTP MRF Router in Gateway mode is somehow pure annoying and causes headaches. But miliage may vary... 

    > Answer to 3.) 

    Lots of fixes and also new issues. Some symtoms are only valid for if you use HTTP MRF Router and some are valid if you dont use HTTP MRF Router. I found the problems without using HTTP MRF Router more acceptable so far. Right now I dont have any known issues on my agenda using latest v16.

    > Answer to 4.)

    Plenty of them. Check the f5 support page and take some time for a reading. 

    > Answer to 5.)

    Use it only for HTTP/2 full-proxy mode (HTTP MRF Router must be enabled in this specific case). Try to avoid the use of iRules or Local Traffic Policies and unnecessary features. Try to run this setup in a clean 1:1 VS->Pool mapping by using VS settings only. Thats probably the best usecase for it right now.

    Cheers, Kai 

F5_LB_Eng's avatar
F5_LB_Eng
Icon for Cirrostratus rankCirrostratus

Hi ,

thanks for you reply..

the issue is  tcpdump -p does not catch server-side traffic in HTTP/2 Gateway-mode

i see the traffic from client to lb and it doest catch server side traffic

1. Can the profile "httprouter" safely used in HTTP/2 Gateway-mode in Rel. 16.1.x?
2. Because we observed a lot of bugs when profile "httprouter" was redundantly used in http/2 Gateway-Mode.
3. Were there any change in usage of profile "httprouter" in Rel. 16.1.x compared to Rel. 15.1.x?
4. Is this behavior a SW-bug?
5. On what condition we need to use httprouter in the profile ..

F5_LB_Eng's avatar
F5_LB_Eng
Icon for Cirrostratus rankCirrostratus
Dec 14, 2022

if we add the httprouter in the profile i can see the server side IP in the tcp dump