Client SSL and SOCKS profiles on same VS
Hello Devcentral, I have a VS that's configured as follows ltm virtual myVS { destination 10.0.0.1:443 ip-protocol tcp mask 255.255.255.255 profiles { clientssl { context clientside } socks { } tcp { } } source 0.0.0.0/0 source-address-translation { type automap } vs-index 69 } The client uses stunnel to establish a TLS session with 10.0.0.1 and then basically sends SOCKS requests into the tunnel. This is accomplished by configuring 127.0.0.1:8080 as SOCKS proxy in the browser settings. Stunnel Configuration: [sockstest] client = yes accept = 127.0.0.1:8080 connect = 10.0.0.1:443 verify = 0 This configuration doesn't work: the browser fails to load any websites. But if i just remove the Client SSL profile from myVS and use 10.0.0.1:443 as SOCKS proxy, the browser successfully loads any web pages. Why is that ?Read or Modify SOCKS payload
Hello Devcentral, even though apparently not much people is playing with the new SOCKS features, here I am with another question on this subject. Can i modify (or read) the SOCKS payload of my clients' requests ? When i dump the full TCP::payload in the CLIENT_DATA event, all i can see is the client's greeting that is part of the SOCKS handshake: 050100 I understand there is a socks-tunnel interface and that the traffic (after the handshake has completed) is likely to be processed at this level but is there a way to read or modify the socks payload from an iRule ?
