what is needed to make floating IP?
I downloaded Big-IP LTM VE 11.3 and start it on my vmware workstation. During configuration from web UI, there's a step where I need to specify self IP and floating IP for VLAN. When I entered and IP address it showed "required". How do I do this on vmware workstation 11?
Convert HTTP iRule to TCP
We have a client/server application that uses a private written client that connects to a server through the LTM. The client app is installed on the users local workstation and then is used to connect to a virtual server on our LTM. The client sends the initial connection request as a malformed header which contains a session id that is then used for persistence. The current iRule we are using contains HTTP commands, so a HTTP profile is required on the virtual server. But, since this not a true HTTP application, we have some issues when using the HTTP profile. So, I am trying to convert the existing iRule from using the HTTP commands and try and use the TCP payload to get the session id. I am an amateur iRule creator, so I was hoping to get some help and to even see if this is possible. The current iRule is listed below. I want to achieve the same result but with using the TCP payload. That way the HTTP profile will not be needed. Current iRule when RULE_INIT { #Sets logging level (0 = no logging 1 = logging) set ::debug 0 #Sets persistence timeout in seconds set ::timeout 900 } when HTTP_REQUEST { #Checks if Content-Session header exists if { [HTTP::header exists "Content-Session"] }{ #Grab Content-Session header value set sessionid [HTTP::header "Content-Session"] if {$::debug}{ log local0. "Content-Session value for [IP::client_addr] is: $sessionid"} #Persist connection based on Content-Session value catch { persist uie $sessionid $::timeout } } } when HTTP_RESPONSE { #Checks for Content-Session header if { [HTTP::header exists "Content-Session"] }{ #Grap Content-Session header value set sessionid [HTTP::header "Content-Session"] if {$::debug}{ log local0. "Content-Session value for [IP::remote_addr] is: $sessionid"} #Setup Persistence record catch { persist add uie $sessionid $::timeout } } }
3rd interface on BIG-IQ VE
Hi, on my BIG-IQ VE 5.1 I have 3 VMXNET3 network adapters. CLI command ifconfig shows all interfaces (eth0,1,2) but if I connect over the Web GUI I can see just interfaces 1.1 and 1.2 Is it possible to use the 3rd interface as well and assign another VLAN to this interface. Unfortunately I couldn't find any instruction how to do it? Thank you in advance. Reg. Janus
F5 r10800 not connected to Cisco Nexus 9000
10G and 25G interfaces on F5 rSeries 10800 (F5os version 1.5.2 ) port fail to establish links with Cisco Nexus switches C93360YC-FX2 (nxos version 9.3.5) both side module model are: type is SFP-H25GB-SR name is F5 NETWORKS INC. part number is OPT-0053 is ther a solution to this problem??