Getting the following error when trying to upgrade device from version 11.4 to 12.0
info: >++++ result: info: mount: proc already mounted or /mnt/tm_install/14834.2RmAWa/proc busy info: mount: according to mtab, proc is already mounted on /mnt/tm_install/14834.2RmAWa/proc info: >---- error: status 8192 returned by command: mount -t proc proc /mnt/tm_install/14834.2RmAWa/proc Could not access configuration destination; sda, 3 . umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy umount: /mnt/tm_install/14834.2RmAWa: device is busy Has anyone else experienced this type of issue? Trying to go from BIG-IP 11.4.1 Build 637.0 Hotfix HF3 to 12.0 Build 0.0.606 (Latest version)Solved832Views0likes3CommentsBigIP 12.0 Active-Active cluster vs Active-Passive cluster
I found a document for BigIP 10.0 that states that "Active/standby mode is the recommended mode for redundant system configuration". I'm trying to find the same information for BigIP 12.0. Is this still the case for 12.0? I have two BigIP 2000 series units clustered.Solved546Views0likes1CommentTCP Monitor after migrating from 11.4.1 to 12.0
I just migrated from 11.4.1 to 12.0. Everything seems fine with the exception of my Pools. They are all marked " Offline (Enabled) The children pool member(s) are down". On 11.4.1 I was using the default tcp monitor and my pool was green. On 12.0 it is down even though my nodes are up. If I change to use gateway_icmp the pool turns green. Any idea why I can't use my default tcp monitor on 12.0?Solved763Views0likes13Comments