Forum Discussion
JustCooLpOOLe If you can reach it you can perform a health check to it. You should be able to configure this as a generic host with no health monitor and then at the pool level you would use a health monitor for the respective website that will return the information you would like to have to classify the site as working.
Thanks paulj !
We have that configuration but still shows down even though I can successfully curl to the site from our GTM. We're looking into the prober pool configuration and routing to determine the source of the health check.
- PauliusMay 22, 2023MVP
JustCooLpOOLe You might take this opportunity on the GTM to perform a tcpdump to see what you are receiving back from the destination. The following should be a close enough syntax and you can change the port if it's HTTPS rather than HTTP.
tcpdump -nni 0.0:nnp host <gtm_ip> and host <destination_IP> and port 80
It is common that sometimes a curl will function slightly different than the health monitor. A good example of this is I was able to perform a curl from my lab LTM to my lab apache server and the response was the one I expected but when I did a very similar request using the health monitor it would fail because the server said it was not able to find the destination that I requested. I ended up having to add in an entry that allowed the server to respond to any request to itself on 80 which I later narrowed it down once I came up with a lab root domain to use.
- JustCooLpOOLeMay 22, 2023Cirrocumulus
Yeah, we're running tcpdumps now to see what's happening. I'll update the thread if we find out what's going on.