Hi,
I am new to F5 and I’m trying to achieve the following setup:
1) I have two Geo-Redundancy Load Balancers that are in Active/Standby mode (one per site). 2) I have four Site-Local Load Balancers that are also in Active/Standby mode (two per site).
On the Geo-Redundancy ones I have VIPs that are pointing towards the VIPs of the Site-Locals and then towards the nodes. I am currently using only ports 8000,8002,10021 and 25. The Geo-Redundancy Load Balancers have LACP trunks towards the uplink and currently I can see that the requests are going via the TRAFFIC IP assigned to this PO interface (based on routing) which is normal. I got requested to change the source IP in the communication between the Geo-Redundancy Load Balancers and the Site-Locals because of Firewall. I am a bit lost now and not sure how to continue. Should I use iRules or Address Translation Pools? It’s important to say that currently I have worked only via the web interfaces of the LB because it was quite friendly and not familiar with the CLI so far.
Device specifications: BIG-IP 2000 Version: BIG-IP 11.4.1 Build 637.0 Hotfix HF3